Post a reply

Options
Add an Attachment

If you do not want to add an Attachment to your Post, please leave the Fields blank.

(maximum 10 MB; please compress large files; only common media, archive, text and programming file formats are allowed)

Options

Topic review

martin

Re: FTP connection lost - automatic repeat - Cancel not possible

What version of WinSCP are you using? Do you have the latest one?
RycoDePsyco

FTP connection lost - automatic repeat - Cancel not possible

FTP connection lost - automatic repeat - Cancel not possible.

English:
If the FTP connection to a device (terminal) with FTP connection is lost, WinSCP tries to reconnect automatically.
So far, that's fine.

If I want to cancel the connection, WinSCP does not allow this.
I have to wait about 15-20 seconds each time until WinSCP displays the error message "Connection failed", only then can I use the "Cancel function".

But since I regularly connect the devices (terminals) and disconnect or change, it is very common that I receive the connection termination message.
The problem with this is that every time I disconnect a device for about 20 seconds or more (when the interval tries to reconnect) I can not continue working.

Therefore, it would be nice if you could improve the cancel function.

While reconnecting, you can not continue working on WinSCP.
You can not switch other tabs or open new tabs (FTP connections).

Hence the attempt to improve this function.
The renewed connection can be aborted immediately.

Many Thanks





German:
FTP Verbindung verloren - automatisches Wiederholen - Abbrechen nicht möglich

Geht die FTP Verbindung zu einem Gerät (Terminal) mit FTP Verbindung verloren, versucht WinSCP die Verbindung automatisch wiederherzustellen.
Soweit ist das völlig in Ordnung.

Möchte ich den Verbindungsaufbau abbrechen, lässt WinSCP dies nicht zu.
Ich muss daher jedes mal etwa 15-20 Sekunden warten, bis WinSCP die Fehlermeldung "Verbindung fehlgeschlagen" anzeigt, erst dann kann ich die "Abbrechen Funktion" nutzen.

Da ich aber regelmäßig die Geräte (Terminals) an und abklemme oder wechsle, kommt es sehr häufig vor das ich die Verbindung-Abbruchmeldung erhalte.
Das Problem daran ist nun, das ich jedes mal wenn ich ein Gerät abklemme, für ca 20 Sekunden oder mehr, (wenn der Intervall wieder versucht zu verbinden) ich nicht mehr weiter arbeiten kann.

Daher wäre es sehr nett, wenn man die Abbrechenfunktion verbessern könnte.

Während des erneuten Verbindungsaufbaues, kann man auch nicht weiter an WinSCP arbeiten.
Man kann bereits andere Tabs nicht umschalten oder neue Tabs (FTP Verbindungen) öffnen.

Daher der Versuch diese Funktion zu verbessern.
Das der erneute Verbindungsaufbau sofort abgebrochen werden kann.

Vielen Dank