winscp starts on the wrong monitor in a dual monitor setup

Advertisement

black94cobra
Donor
Joined:
Posts:
1
Location:
Arizona

winscp starts on the wrong monitor in a dual monitor setup

i use a laptop with an external monitor. the external monitor is set to be my primary monitor so that i can run with the laptop closed. the first time i start winscp after a reboot it always starts on the laptop monitor. i have to log on to a site with winscp and then drag it over to the external monitor. after that it always starts on the external monitor until the next reboot

Reply with quote

Advertisement

martin
Site Admin
martin avatar
Joined:
Posts:
40,476
Location:
Prague, Czechia

Re: winscp starts on the wrong monitor in a dual monitor setup

Thanks for your report.
I have sent you an email with a debug version of WinSCP to the address you have used to register on this forum.

Reply with quote

glenneroo
Joined:
Posts:
2

I am having similar issues with 5.9.3 (build 7136). I have 3 screens configured as: 2-1-3 where screen #3 is a projector which is usually turned off. When I start WinSCP, it starts on #3 which I can't see - so I use Win-Left hotkey to get the Login window over to #1. After pressing Login, the login-status window opens on #2 in the very lower left corner, then the actual Commander window is hidden and I can't get it to show anywhere. If there is an error, the Login window is sometimes shown again on #2 in the lower left corner.

Reply with quote

martin
Site Admin
martin avatar

Thanks for your report.
I have sent you an email with a debug version of WinSCP to the address you have used to register on this forum.

Reply with quote

Advertisement

Advertisement

You can post new topics in this forum