set active mode in script

Advertisement

ddouble
Joined:
Posts:
2

set active mode in script

I see that version 5.0.2 had an "Option to enable active mode with FTP protocol in scripting"
I have a need to do that but can not figure out how to set it in my script.
I have no trouble doing it interactively but i really need to have my script set it on the site i am connecting to.

p.s. i am using WinSCP version 5.0.5

Reply with quote

Advertisement

ddouble

set active mode in script

Thank you, that works fine! that's exactally what i was looking for. I tried putting the "passive=off" command every else EXCEPT right after the open command.

Reply with quote

Advertisement

You can post new topics in this forum