I have 3 hard drives connected to my PC.
Transferring files using WinSCP only to one of them but can't eject other ones - even if nothing is being transferred to them (and nothing was transfered during that session).
Basically if I'm in the middle of some transfer, either I have to wait until it is finished and close WinSCP or cancel current transfer, close WinSCP and then after ejecting HDD, open WinSCP again and set up my queue from scratch (WinSCP unfortunately doesn't keep unfinished queue and can't resume).
It is a bit annoying but I have started planinig closing WinSCP from time to time just to have an opportunity to eject some media.
Would please record a short video showing the problem (start WinSCP, do the transfer, try to eject drive)? Eg. using <invalid hyperlink removed by admin>