Re: SSHv2 with DSA publickey authentication
Both DSA and public key authentication is already supported by WinSCP 2.1 #119.
- martin
Post a reply
Before posting, please read how to report bug or request support effectively.
Bug reports without an attached log file are usually useless.
Topic review
- martin
Re: SSHv2 with DSA publickey authentication
Is there any way to use DSA auth with SSHv2? That's the only authentication I allow, and I would rather avoid enabling RSA authentication.
Not yet. You may wait for January, when new version that would support DSA, should be already released.
Another quick question - on the Advanced tab, under "Preferred SSH protocol version", 2 is greyed out - how can I enable that?
There are two possibilities: you've either entered path to key on "Basic" tab or you've selected "DES" algorithm. Both is not supported for SSH2 by current version.
- Benny
SSHv2 with DSA publickey authentication
Hey folks,
Is there any way to use DSA auth with SSHv2? That's the only authentication I allow, and I would
rather avoid enabling RSA authentication.
Another quick question - on the Advanced tab, under "Preferred SSH protocol version", 2 is greyed out - how can I enable that?
Thanks a bunch! :)
Benny
Is there any way to use DSA auth with SSHv2? That's the only authentication I allow, and I would
rather avoid enabling RSA authentication.
Another quick question - on the Advanced tab, under "Preferred SSH protocol version", 2 is greyed out - how can I enable that?
Thanks a bunch! :)
Benny