Latest beta not navigating correctly on folders which are NTFS junctions

As stated, the latest beta gives a strage errore when navigating junctions on NTFS drives, where the 6.5.x never had a single problem with them.

Also, this happens on commander GUI on Windows 11 with the latest service packs.

Thanks for your report. I cannot reproduce this.
This is about the local panel, right? And a directory junction?
Does it happen with any directory junction? Or with some specific targets only? I've tried both a junction pointing to another folder on the same drive and a junction pointing to another (Windows) machine. Both can be entered/opened (if that's what you mean by navigating).
Also, please post the "strage errore".

I must say that...

The error has appeared one time at the first execution after upgrading from 6.5.5, but then...

It disappeared, and I never managed to make it appear again.

So: version 6.5.5 installed -> Upgrade to 6.6.1 -> Run -> connect to site -> Try to use the commander UI enter a local folder which is a junction to another folder on the same ntfs drive -> Strange error (403? 430?) .
Restart WinSCP, try again, no error whatsoever...

I'm baffled!

Ok, thanks.

One screenshot of the error...

Another screenshot of the error, this one when directory navigation sync is off...