This is an old revision of the document!
Session URL
On command-line and in parameter of scripting command open
, you can, in addition to using site name, specify an ad-hoc session using URL.
Advertisement
Syntax
sftp|ftp|ftps|scp :// [ <username> [ : <password> ] [ ; <fingerprint> ] @ ] <host> [ : <port> ] /
Elements
The only mandatory part is host
. The host can either be a host name (such as example.com
), an IPv4 address (such as 127.0.0.1
) or an IPv6 address surrounded by square brackets (such as [2001:db8:85a3:8d3:1319:8a2e:370:7348]
).
You should also always explicitly specify a protocol (sftp
, ftp
or scp
, the ftps
protocol is FTP over TLS/SSL).1 For all protocols WinSCP-specific alternative is supported, with winscp-
prefix.
Most URL’s will include also username
.
The port
needs to be specified only, when it differs from the default port for the protocol (22 for sftp
/scp
, 21 for ftp
and 990 for implicit ftps
).
SSH Host Key Fingerprint
The SFTP/SCP URL can optionally contain expected SSH host key fingerprint with syntax fingerprint=<fingerprint>
.
Providing the fingerprint in the session URL is mainly useful, if you need to provide all session settings using URL only, such as using a hyperlink on a web page.
For security reasons, fingerprint provided in session URL does not override any fingerprint already cached on the machine. This for instance differs from behavior, when fingerprint is provided using -hostkey
switch of open
command in scripting.
Advertisement
Format of the fingerprint for URL2 somewhat differs from format used in other WinSCP features (-hostkey
switch of open
command in scripting for instance). To convert WinSCP fingerprint format to URL format:
- Drop bit count part (the number after
ssh-rsa
orssh-dsa
, typically2048
or1024
); - Replace remaining space and all colons (
:
) with a dash sign (-
).
For example WinSCP fingerprint ssh-rsa 2048 ee:f3:c1:59:4d:b4:e2:c5:da:22:3a:6e:97:a0:28:29
converts to ssh-rsa-ee-f3-c1-59-4d-b4-e2-c5-da-22-3a-6e-97-a0-28-29
.
Special Characters
Special characters (like @
in username, see example below) have to be encoded using %XX
syntax, where XX
is hexadecimal UTF-8 code.3
Common special characters are:
- space:
%20
or+
%
:%25
(percent sign)+
:%2B
(plus sign)/
:%2F
(slash)@
:%40
(at sign):
:%58
(colon);
:%59
(semicolon)
Examples
sftp://martin:mypassword@example.com/ sftp://root@example.com:2222/ ftp://127.0.0.1:2121/ ftp://[2001:db8:85a3:8d3:1319:8a2e:370:7348]:2121/ sftp://martin;fingerprint=ssh-dss-0b-77-8b-68-f4-45-b1-3c-87-ad-5c-be-3b-c5-72-78@example.com/
- Protocol is
sftp
by default, but the default can be changed.Back - Fingerprint format for URL is based by draft-ietf-secsh-scp-sftp-ssh-uri.Back
- For multi-byte codes, use
%
before every byte, for instance to represent pound-sign£
use%C2%A3
.Back