WinSCP SFTP download gets error Invalid parameter each time after 4126KB data is downloaded

Advertisement

zousijiu
Guest

WinSCP SFTP download gets error Invalid parameter each time after 4126KB data is downloaded

Hello, I'm trying to use WinSCP to download file from a SFTP, however, I got the following error message every time after 4126KB data downloaded. If the file is less than 4126KB, there is no problem.

One of the parameters was out of range, or the parameters specified cannot be used together.
Error code: 23
Error message from server: Invalid parameter

But there is no problem with fillezilla.
I tried to change the settings like Timeout, protocol, etc, but always the same error.
Is there any configuration can cause this? Client side or Server side?

Any help would be greatly appreciated.

Thanks

Reply with quote

Advertisement

martin
Site Admin
martin avatar
Joined:
Posts:
32,073
Location:
Prague, Czechia

Re: WinSCP SFTP download gets error Invalid parameter each time after 4126KB data is downloaded

Please attach a full session log file showing the problem (using the latest version of WinSCP). Set logging level to "Debug 1".

To generate the session log file, enable logging, log in to your server and do the operation and only the operation that causes the error. Submit the log with your post as an attachment. Note that passwords and passphrases not stored in the log. You may want to remove other data you consider sensitive though, such as host names, IP addresses, account names or file names (unless they are relevant to the problem). If you do not want to post the log publicly, you can mark the attachment as private.

Reply with quote

Advertisement

You can post new topics in this forum